Subject: Dual Nic Problems
From: Bryn Hughes (bhughes@vcc.bc.ca)
Date: Fri Dec 01 2000 - 19:40:30 EST
I can't quite figure out how to get Netatalk to behave properly with 2 NICs. Here's my setup:
eth0: Our 'admin' lan, with a proper public IP address
eth1: Our 'student' lan, with a 192.168.xxx.xxx address
If I set the gateway device in my network config script as "eth1", I can connect to netatalk from both LANs via TCP/IP, however I always get connected to card 'eth1' regardless of which vlan I'm connecting from. (or at least I'm connected to the IP address of that card). If I set the gateway device to eth0, I can actually get outside with my server, but I cannot connect via TCP/IP to the server unless I manually specify the IP address and port. I can see the server in the chooser fine, and it shows up in the correct zone. Connecting to it over Appletalk works fine.
I can send in my config scripts if anyone thinks it would help... but I'd love to hear everyone's ideas!
Bryn
This archive was generated by hypermail 2b28 : Wed Jan 17 2001 - 14:32:43 EST