Subject: Re: [netatalk-admins] AppleTalk crashes EEPro100 on a bonded etherchannel
From: Chip Mefford (cmefford@avwashington.com)
Date: Wed Nov 25 1998 - 08:50:50 EST
On Tue, 24 Nov 1998, a sun wrote:
>
> Start Netatalk. nbprgstr fails to register an AppleTalk address/name
> for the system until I add a line "eth0 -phase 2" into
> /etc/atalk/atalkd.conf. After adding it, Netatalk starts
> normally. This indicates that atalkd can't understand that eth1 is a
> slave channel.
>snip<
> -a
> asun@u.washington.edu
>
Sorry for my ignorance, but does this somehow mean that atalkd wont bond
to eth1, ignoring eth0 even if atalkd.conf only has a eth1 argument?
Reason I ask is this is how I have been trying to set netatalk up. I had
it working this way under 1.3, and for a little while under 1.4b2, but it
was unsatisfactory due to my ignorance, I've been at it again, and thus
far have been unable to get it to run at all.
atalkd.conf
#
#eth1 -phase 2 -net 0-65534 -addr 65280.158
eth1 -phase 2
messages log
Nov 18 15:40:42 video1 atalkd[585]: restart (1.4b2+asun2.1.0)
Nov 18 15:40:43 video1 atalkd[585]: zip_getnetinfo for eth1
Nov 18 15:41:12 video1 atalkd[585]: config for no router
Nov 18 15:41:13 video1 atalkd[585]: ready 0/0/0
Nov 18 15:49:13 video1 atalkd[585]: done
???
thanx in advance for any insights
chipper
This archive was generated by hypermail 2b28 : Sat Dec 18 1999 - 16:33:46 EST