Subject: Re: Problems with installation
From: Jesse Swensen (jrs@pagesz.net)
Date: Sat Jun 14 1997 - 20:10:05 EDT
In an earlier message I wrote:
>I am trying to install netatalk14b2 on NetBSD running on a Macintosh
>SE/30. I have been able to compile and install, but when I run rc.atalk I
>get an error:
>
>bind: Can't assign requested address
>
>I am at a loss as what to look for and/or where. Any ideas?
I have continued trying to hunt down the problem. It seems that the
address it can not bind to is the ethernet card. If I run the rc.atalk
before running netstart, it at least doesn't give me the above error. It
just give me a usage error instead.
Usage: nbprgstr obj:type@zone
It would make sense to start the network stuff first before setting up
netatalk. Suggestions???
Jesse
___________________________________________________________________
Jesse Swensen 111 Vashon CT. (919) 481-3480 (home)
jrs@pagesz.net Cary, NC 27513 (919) 481-3363 (FAX)
"Intel Inside" The worlds most used warning label.
___________________________________________________________________
This archive was generated by hypermail 2b28 : Sat Dec 18 1999 - 16:24:56 EST